Furuno FAR-2218 Installation Manual page 81

2. Unfasten three bolts from the cable clamp. Lay the cables in respective cable slots
so their armors rest in the slots.
Loosen eight bolts.
3. Attach the appropriate WAGO connectors (pre-attached) to the appropriate ca-
bles, and then connect the antenna, sub monitor and serial cables to the RF-TB
Board shown in the following figure. For how to connect the WAGO connector,
see "WAGO connector" on page 2-5. For pin arrangement, see the interconnec-
tion diagram at the back of this manual.
Note 1: Make sure to pass the cable through the specified locking wire saddle.
Note 2: A terminal opener is provided on the RF-TB Board.
• Destination of Antenna cable
Power line: TB801 through the locking wire saddle (A).
LAN cable: J821 through the locking wire saddles (A and B, three places.)
Shield of power line: Screw (C)
Shield of LAN cable: Screw (D)
( B )
( B )
LAN cable LAN cable
( A )
Power line Power line
• Destination of cable for the sub monitor
Signal line: TB803 through the locking wire saddle (A).
Coaxial cable: TB804
Shield of signal cable: Screw on fixing plate (C)
Remove three bolts.
Side view for LAN port
( C )
Antenna cable
For Serial cable
For Antenna cable
For Sub monitor cable
J821
( D )
( B )
TB801
2. WIRING
( A )
( B )
2-41