Furuno FAR-2218 Installation Manual page 87

TTYCSLA series cable (for serial)
Armor
Pass the heat-resistant tubing (supplied) onto the drain wire.
Vinyl tape
2.7.2 How to connect cables inside the processor unit
Connect the ground wire between the ground termi-
nal on the chassis and the ship's earth.
How to open/close the top cover
Unfasten six screws (M4 8) to open the top cover
from the processor unit.
After the appropriate cable connections are com-
pleted, fasten six screws to close the top cover.
Connection of Antenna cable
For existing antenna cable, see section 2.9 "LAN Signal Converter".
1. Remove the spacers to pass the antenna cable on the upper plate.
2. Fasten the cable to the post part of the plate with a cable tie (local supply).
Note: Be sure the vinyl sheath of the cables is on the post.
80 80
100 100
Sheath
L
5
Drain wire Drain wire
6
Crimp-on lug
Ground terminal
Armor
Cable tie
2. WIRING
(unit: mm)
Cable type (JIS) L
590
TTYCSLA-1Q
720
TTYCSLA-4
TTYCSLA-7 570
Ground terminal
Cable tie
Upper
plate
Antenna cable
2-47