Transceiver Unit - Furuno FAR-2218 Installation Manual

13. Fasten the coaxial connector to the waveguide flange with three sets of M6 20
hex bolts, M6 spring washers and M6 nuts.
REAR REAR REAR
14. Tape the cable with two or more
turns of self-bonding tape then wrap
with PVC tape.
15. Secure the cable with fixing bands (supplied) or the op-
tional clamping metal (Type: 03-011-3228, Code no.:
100-049-620) to the mast and to the wheelhouse struc-
ture. For the optional through-deck cable gland, see the
outline drawing at the back of this manual.
16. Reconnect the performance monitor connector (J807).
17. Check that the gasket on the front and rear cover is seated properly, then close
the covers. The torque for the fixing bolts must be 21.0 N•m.
Note: For the de-icer specifications, take care not to hit the heater elements on
the chassis or radiator. If the heater hits something, unfasten the fixing screws for
the heater to adjust the position of the heater. Then fix the heater again.
2.6

Transceiver Unit

The TR-DOWN radar requires the transceiver unit as follows:
• Transceiver Unit RTR-108 for X-band radar (FAR-2328W)
• Transceiver Unit RTR-109 for S-band radar (FAR-2338SW)
2.6.1 How to fabricate the cables
For how to connect the LAN modular plug, see "LAN cable" on page 2-4. For how to
connect the WAGO connector, see "WAGO connector" on page 2-5.
TTYCYSLA-10 (for serial cable)
Clamp the armor with the cable clamp.
Coat surface of flange with
waterproofing compound.
Hex bolt Spring
washer
5 cm
2. WIRING
Nut
Coaxial
connector
ø7
Fixing band
2-39