Furuno FAR-2218 Installation Manual page 33

1. Prepare a cutout in the location as shown in the figure as below.
2. Set the control unit to the cutout.
3. Attach the flush mount fixtures to the control unit with four screws from the rear
side.
4. Screw the wing screw to each mounting plate and then insert hex. bolt to each
wing screw.
5. Fasten each wing screw and then fasten the hex. nuts as shown in figure below.
Flush mount, using with panel (for RCU-014 only)
Use the optional flush mount kit OP03-198 to mount the control unit to a console panel
using with the panel. See the mounting procedure in the kit for details.
1.4.3 Installation of RCU-016 connected with RCU-014
388 ±2 mm (153')
RCU-014
RCU-014
Side view of control units
170 ±2 mm (67') 170 ±2 mm (67')
150 ±2 mm (59')
RCU-015/016
RCU-015/016
1. Pass the cable from
RCU-016.
2. Connect the
RCU-016 cable
connector to J502.
3. Clamp the copper
part of the cable with
the cable clamp.
1. INSTALLATION
176 ±2 mm (69') 176 ±2 mm (69')
1-15