1.5
Processor Unit
1.5.1
Installation considerations
Keep in mind the following points when selecting a location.
• Locate the processor unit away from heat sources because of heat that can build
up inside the cabinet.
• Select a location where the vibration is minimal.
• Locate the equipment away from places subject to water splash and rain.
• Make the service clearance of 100 mm in front of the vent hole (left side).
• Leave sufficient space at the sides and rear of the unit to facilitate maintenance.
• Be sure to connect the ground wire (between the earth terminal on the chassis and
the ship's earth).
• A magnetic compass will be affected if the processor unit is placed too close to the
magnetic compass. Observe the compass safe distances in the SAFETY IN-
STRUCTIONS to prevent interference to a magnetic compass.
• Leave the dummy plate fastened, to prevent the wrong operation of the power
switch. The items behind the plate are for use by the serviceman.
Processor unit, front view
• Install the processor unit on the floor, or on a bulkhead with the following direction
(horizontal), because of the DVD drive unit.
OK
Keep the dummy
plate in this
position.
UP
1. INSTALLATION
1-11