Furuno FAR-2218 Installation Manual page 113

• Setting alert list: Select the alert to activate. The ac-
tivated alerts are indicated with an underline.
For example shown in the right figure, [TT NEW
TARGET(A)] and [TT TARGET LOST(A)] are acti-
vated.
The available alerts as as follows;
• TT NEW TARGET(A)
• TT NEW TARGET(C)
• TT TARGET LOST(A)
• TT TARGET LOST(C)
• TT COLLISION(A)
• TT COLLISION(C)
• TT TGT FULL(AUTO)(A)
• TT TGT FULL(AUTO)(C)
• TT TGT FULL(MAN)(A)
• TT TGT FULL(MAN)(C)
• AIS NEW TARGET(A)
• AIS NEW TARGET(C)
• AIS TARGET LOST(A)
• AIS TARGET LOST(C)
• AIS COLLISION(A)
• AIS COLLISION(C)
• ACTIVE AIS FULL(A)
• ACTIVE AIS FULL(C)
• AIS DISPLAY FULL(A)
• AIS DISPLAY FULL(C)
ALERT DATA OUT
Select the alert output format, [ALR] (Set Alarm State) or [ALF] (Alert Sentence, de-
fault).
AIS ALERT I/F
Set the AIS alert interface.
[OFF] does not output AIS alerts (default).
[LEGACY]: For connection to FA-100, FA-150 or FA-170 where the AIS mode is [LEG-
ACY].
[IF1]: For connection to FA-150 or FA-170 where the AMS mode is [AlertIF1].
• NO AZIMUTH SIGNAL
• NO HEADLINE SIGNAL
• NO TRIGGER SIGNAL
• NO VIDEO SIGNAL
• CTRL UNIT COM ERROR
• PM COM ERROR
• TUNE ERROR
• RADAR ANT COM ERROR
• MTR-DRV COM ERROR
• RF-CONVERTER COM ERR
• NO GYRO SIGNAL
• NO LOG(BT) SIGNAL
• NO LOG(WT) SIGNAL
• NO POSITION SIGNAL
• NO COG/SOG SIGNAL
• NO UTC SIGNAL
• XTD LIMIT EXCEEDED
• ECDIS COM ERROR
• ARRIVED AT WPT
• OUT OF ANCHOR ZONE
3. ADJUSTMENTS
3-15