Antenna Unit For S-Band, Tr-Down Radar - Furuno FAR-2218 Installation Manual

10) Attach the supplied earth label over the earth label currently attached near the
grounding terminal.
Note: If it is necessary to open the front cover after installing the DE-ICER kit,
remove the de-icer power cable from the locking wire saddle shown in the fol-
lowing figure then detach the cover slowly to prevent damage to the heater.
15. Reconnect the performance monitor connector (J807).
16. Check that the gasket on the front and rear cover is seated properly, then close
the covers. The torque for the fixing bolts must be 21.0 N•m.
Note: For the de-icer specifications, take care not to hit the heater elements on
the chassis or radiator. If the heater hits something, unfasten the fixing screws for
the heater to adjust the position of the heater. Then fix the heater again.
2.5

Antenna Unit for S-band, TR-DOWN Radar

2.5.1 How to fabricate the cables
For how to connect the WAGO connector, see "WAGO connector" on page 2-5.
TTYCYSLA-10 (for serial cable)
10 10
Outer sheath
FRONT FRONT
390 390
30 30
Drain wire Drain wire
Armor Inner sheath
Vinyl tape
Grounding terminal Grounding terminal
Remove the de-icer power cable from the locking Remove the de-icer power cable from the locking
wire saddle to open the front cover. wire saddle to open the front cover.
200 200
6
Pass the heat shrink tubing (local supply)
onto the drain wire.
2. WIRING
Earth label
6
Crimp-on lug
(unit: mm)
2-33