Monitor Unit; Mounting Considerations - Furuno FAR-2218 Installation Manual

2. WIRING
1.
Fixing plate
2.8

Monitor Unit

For the wiring of the monitor unit, see the operator's manual supplied with the monitor
unit.

Mounting considerations

Standard type
• Connect the radar main monitor to the DVI1.
• Connect the sub radar monitor to the DVI2.
VDR connection
To connect a VDR, it is necessary to output data in analog format. To connect a
VDR to the DVI-I port, use the optional DVI-BNCX5+GND-L2.0 cable to output the
RGB signal from the DVI-I. See the operator's manual supplied with the VDR. Ad-
justment of the output is necessary.
Menu Setting
The [INSTALLATION SETTING] menu appears only when the power is turned on for
the first time after installation of the monitor unit.
INSTALLATION SETTING
EXT BRILL CTRL
SERIAL BAUDRATE
COLOR CALIBRATION
KEY LOCK
SAVE AND EXIT
Adjust the settings referring to the following table.
*: [DVI PWR SYNC] is the slide switch at the bottom rear of the monitor unit. Confirm
that this switch is set to [ON] (default setting). See Slide switch below for details.
2-52
2.
Grounding
Cable
Assembly
RS-485 (OFF/DVI1/DVI2/RS-232C/RS-485/USB)
4800bps (4800/9600/19200/38400)
ON (OFF/ON)
ON (OFF/ON)
YES (NO/YES)
EXT BRILL COLOR
CTRL CALIBRATION
DVI OFF
3.
Fix with two
M5 screws.
Menu
KEY DVI PWR
LOCK
ON
4.
Cable of VDR
Menu item
SYNC*
ON