The Processor Unit; Turning The Power On/Off; How To Find Version Number Of Ecdis Software; Diagnostics - Furuno FEA-2107-BB Operator's Manual

1. Introduction
1.3

The Processor Unit

The processor unit is the heart of the system, responsible for the loading, storing, updating and processing of
electronic sea charts, with the DVD-ROM drive or floppy disk drive. The DVD-ROM and floppy disk drives are
behind the lid on the front panel.
1.4

Turning the Power On/Off

The system may be turned on by turning on the power switch at the rear of the processor unit then pressing the
POWER switch on the Control Unit, until you feel a "click." At this time the equipment releases a beep. To turn off
the system, reverse this sequence.
Note: The amount of resources used increases over time, sometimes slowing down operation. If operation seems to
be slow, re-set the power, when use of the equipment is not required; for example, when in port.
1.5

How to Find Version Number of ECDIS Software

The ECDIS software version number is displayed in the information area, next to the scale factor.
Version no.
XX.XX XX.XX
1.6

Diagnostics

The ECDIS has two types of diagnostic tests. One type (several tests) checks the functionality of the equipment and
the other type calibrates the monitor. This manual provides only the instructions for testing the keyboard. For further
details about diagnostic tests, see the service manual.
1-4
DVD-ROM drive
Floppy dIsk drive