Furuno FAR-2218 Installation Manual page 55

2.3.2 How to connect the cables for X-band (TR-DOWN) radar
1. Unfasten four bolts from the rear cover to remove the rear cover. If the de-icer is
already installed or will be installed, remove two bolts inside the antenna to re-
move the front cover.
Note 1: The cable for the performance monitor is connected between the rear
cover and the RF-TB Board in the antenna unit. Open the cover slowly to prevent
damage to the cable and connector.
Note 2: If the de-icer is to be installed, spread open the right and left heater ele-
ments on the cover, then remove the front cover, being careful not to hit the ele-
ments on the radiator or chassis.
2. Disconnect the performance monitor connector (J807) from the RF-TB Board.
3. Unfasten four screws to open the cable entrance cover.
Note: The orientation of the cable entrance can be changed. See "How to change
the orientation" on page 2-8.
REAR REAR
Cable cover Cable cover
For de-icer installation
J807 J807
(performance (performance
monitor) monitor)
2. WIRING
2-15