Antenna Unit For S-Band, Tr-Up Radar - Furuno FAR-2218 Installation Manual

2. WIRING
4) Connect the waveguide flange and then fix with the bolt.
Note 1: If it is necessary to open the front cover after installing the de-icer kit,
remove the de-icer power cable from the locking wire saddle shown in the fol-
lowing figure then detach the cover slowly to prevent damage to the heater
element.
Note 2: For the de-icer, take care not to hit the heater elements on the chassis
or radiator. If the heater hits something, unfasten the fixing screws for the
heater to adjust the position of the heater. Then fix the heater again.
5) Wipe out the excess adhesive of the flange.
12. Check that the gasket on the front and rear covers is seated properly, then
close the covers. The torque for the fixing bolts must be 10.0 N•m.
2.4

Antenna Unit for S-band, TR-UP Radar

2.4.1 How to fabricate the cables
For how to connect the LAN modular plug, see "LAN cable" on page 2-4. For how to
connect the WAGO connector, see "WAGO connector" on page 2-5.
RW-00135
10 10
Outer
Armor
sheath
RW-9600/6895 (for retrofit)
To use the existing cable (RW-9600/6895) for the retrofit, two optional kits are re-
quired. For the LAN Coaxial Converter, see section 2.9 "LAN Signal Converter" for de-
tails.
• LAN Signal Converter: Type: OP03-247-2 (for Magnetron radar)
• Retrofit Cable Kit: Type: OP03-255-1
2-20
FRONT FRONT
Magnetron radar: 520 Magnetron radar: 520
Solid state radar: 540 Solid state radar: 540
40 40
Vinyl tape
Inner sheath
Type: OP03-247-1 (for solid state radar)
Remove the de-icer power cable from the locking Remove the de-icer power cable from the locking
wire saddle to open the front cover. wire saddle to open the front cover.
Power line
Outer Shield Outer Shield
(unit: mm)
6
LAN cable LAN cable
Inner Shield Inner Shield