Figure 3-11. Pneumatic Connections, Basic Configuration Using Gas Dilution Calibrator; Table 3-7. Inlet / Outlet Connector Descriptions - Teledyne T101 Operation Manual

Getting Started
REAR PANEL LABEL
SAMPLE
EXHAUST
SPAN
ZERO AIR
Calibrated
H S GAS
2
(At high
concentration)
MODEL 701
Zero Air
Generator

Figure 3-11. Pneumatic Connections, Basic Configuration Using Gas Dilution Calibrator

40

Table 3-7. Inlet / Outlet Connector Descriptions

Connects the sample gas to the analyzer. When operating the analyzer without
zero span option, this is also the inlet for any calibration gases.
Connects the exhaust of the analyzer with the external vacuum pump.
On units with zero/span/shutoff valve options installed, connect a gas line to
the source of calibrated span gas here.
On Units with zero/span valve or IZS option installed, this port connects the
zero air gas or the zero air cartridge to the analyzer.
MODEL T700 Gas
Dilution
Calibrator
Teledyne ML – T101 Operation Manual
FUNCTION
Source of
SAMPLE Gas
Calibration
Sample
Chassis
Exhaust
Span
Zero Air
Removed
during