Basler DGC-2020 Instruction Manual page 32

THRESHOLD
ACTIVATN DLY
HIGH FUEL LEVEL
o
ENABLE
THRESHOLD
ACTIVATN DLY
ACTIVE DTC (Visible when DTC Support is enabled.)
o
ENABLE
ECU COMMS FAIL (Visible when ECU Support is enabled.)
o
ENABLE
COOLANT LEVEL
o
ENABLE
THRESHOLD
AVR OUTPUT LIMIT (Visible when LSM-2020 is enabled.)
o
ENABLE
ACTIVATN DLY
GOV OUTPUT LIMIT (Visible when LSM-2020 is enabled.)
o
ENABLE
ACTIVATN DLY
INTERGENSET COMM FAIL (Visible when LSM-2020 is enabled.)
o
ENABLE
LSM COMM FAIL (Visible when LSM-2020 is enabled.)
o
ENABLE
ID MISSING (Visible when LSM-2020 is enabled.)
o
ENABLE
ID REPEAT (Visible when LSM-2020 is enabled.)
o
ENABLE
CEM COMM FAIL (Visible when CEM-2020 is enabled.)
o
ENABLE
• ALARMS
HIGH COOLANT TEMP
o
ENABLE
THRESHOLD
ARMING DELAY
LOW OIL PRESSURE
o
ENABLE
THRESHOLD
ARMING DELAY
LOW FUEL LEVEL
o
ENABLE
THRESHOLD
ACTIVATN DLY
OVERSPEED
o
ENABLE
THRESHOLD
ACTIVATN DLY
COOLANT LEVEL
o
ENABLE
THRESHOLD
The HIGH COOLANT TEMP and LOW OIL PRESSURE alarms have an
ARMING DLY setting that disables the alarm for the specified time after engine
startup.
• SENDER FAIL
COOL TEMP SENDR FAIL
o
CONFIG TYPE
ACTIVATN DLY
2-8
NOTE
DGC-2020 Human-Machine Interface 9400200990 Rev I