Basler DGC-2020 Instruction Manual page 114

Call-
Symbol
Out
Holding the left mouse button down on a metering tab and dragging it to one of
the four arrow boxes will place it inside the selected window on the location
A
selected. To place the metering tab as a tab inside the selected window, drop it
on the tabs button in the center of the arrow buttons.
Holding the left mouse button down on a metering tab and dragging it to this
arrow box will place it across the top of the screen. Click on the
B
to dock it on the top bar. To display a screen that is docked, simply use the
mouse to hover the pointer over the tab on the top bar.
Holding the left mouse button down on a metering tab and dragging it to this
arrow box will place it across the side of the screen. Click on the
C
to dock it on the side bar. To display a screen that is docked, simply use the
mouse to hover the pointer over the tab on the side bar.
Holding the left mouse button down on a metering tab and dragging it to this
arrow box will place it across the bottom of the screen. Click on the
D
(thumbtack) to dock it on the bottom bar. To display a screen that is docked,
simply use the mouse to hover the pointer over the tab on the bottom bar.
Holding the left mouse button down on a metering tab and dragging it to
anywhere other than an arrow box will place it as a floating metering screen.
E
This floating screen can later be closed by clicking on the
corner. It may also be dragged to one of the arrow boxes used for docking.
4-58
E
D
Figure 4-55. Metering, Docking Options
Table 4-2. Explanation of Call-Outs on Figure 4-55
DGC-2020 BESTCOMSPlus Software
B
A
C
Explanation
(thumbtack)
(thumbtack)
in the upper right
9400200990 Rev I