Basler DGC-2020 Instruction Manual page 3

This instruction manual provides information about the operation and installation of the DGC-2020 Digital
Genset Controller. To accomplish this, the following information is provided:
•
General Information and Specifications
•
Controls and Indicators
•
Functional Description
•
Graphical User Interface Operation
•
Installation
•
Maintenance and Troubleshooting
•
LSM-2020 (Load Share Module)
•
CEM-2020 (Contact Expansion Module)
•
Appendices containing Time Overcurrent Characteristic Curves and Modbus™ Communication
To avoid personal injury or equipment damage, only qualified personnel should
perform the procedures in this manual.
Be sure that the controller is hard-wired to earth ground with no smaller than 12
AWG copper wire attached to the chassis ground terminal on the rear of the unit.
When the controller is configured in a system with other devices, it is
recommended to use a separate lead to the ground bus from each unit.
9400200990 Rev I
INTRODUCTION
WARNING!
NOTE
DGC-2020 Introduction i