6 ] Removing The Cutter Unit Assy And Mecha Assy - Brother QL-1060N Service Manual

[ 6 ] Removing the Cutter Unit ASSY and Mecha ASSY

(1) Take out the harness from the hole of the under cover.
(2) Remove the two screws and remove the cutter unit ASSY from the mecha ASSY.
Screws
Fig. 3.1-25 Removing the Cutter Unit ASSY and Mecha ASSY (1)
(3) Pull the harnesses out of the under cover. Remove the two screws and remove the
mecha ASSY from the under cover while pulling both sides of the under cover outwards.
Mecha ASSY
Under cover
Fig. 3.1-26 Removing the Cutter Unit ASSY and Mecha ASSY (2)
Mecha ASSY
Cutter unit ASSY
III- 19
Harness
Hole
Screws
Harness
Under cover