Brother QL-1060N Service Manual page 112

(4) Set the die cut roll of 62mm x 100mm into the machine and click the "Print test(62mm
2Labels) (B)" button to implement the test print. (Refer to Print result (B).)
(5) Measure the top margin of the 2nd page of the print result. It is OK if the top margin is
3mm±0.25mm. (Two pages are printed. 1st page: blank, 2nd page: print pattern for
inspection)
If it is not 3mm±0.25mm, select the appropriate "Adjusted value" and click the "Apply
(1)" button. Then, click the "Print test (62mm 2Labels) (B)" button and print the print
pattern for inspection again. (Refer to Fig. 22.)
Check that the top margin of the print result is 3mm±0.25mm.
If the margin is adjusted, select the appropriate
Adjusted value and click the "Apply (1)" button.
Printing direction
3mm±0.25mm
Fig. 22 "Adjustment print test" screen
20
Print result (B)
Print the print pattern
for inspection.