Brother QL-1060N Service Manual page 97

[ 2 ] Use Procedure of the Maintenance Software Tool
(1) Start the maintenance software. (File name: QL1060NtstSE.exe) (Refer to Fig. 4.)
(2) Connect the machine to your PC with the USB cable and turn the power supply button
ON.
Note: When new hardware is detected and the "New hardware detection wizard"
screen appears, press the "Cancel" button.
(3) Enter the last nine digits of the serial number into the "Serial No." column, which is
found on the nameplate attached on the under cover.
(4) Click the "Read MAC address" button to read the MAC address from the machine.
If transmission with the machine is failed:
It causes an error, and the "Cannot transmit" message appears in the dialog box.
If the MAC address is not standard, also, it causes an error, and the "MAC address
error" message appears.
If one of those errors occurs:
Click the "Read MAC address" so that the MAC address is acquired again. Or, click
the "Clear Serial No" button so that the serial number is cleared, and the software
returns to the initial state.
After entering the serial number,
the MAC address is read.
Fig. 4 Serial number and MAC address acquiring screen
(3)
(4)
5