Brother QL-1060N Service Manual page 113

(6) Set the die cut roll of 62mm x 100mm into the machine and click the "Print test(62mm
1Label) (C)" button to implement the test print. (Refer to Print result (C).)
(7) Measure the top margin on the print result and make sure that the margin is
3mm±0.25mm.
If it is not in this range, select the appropriate "Adjusted value" and click the "Apply
(2)" button. Then, click the "Print test (62mm 1Label) (C)" button and print the print
pattern for inspection again. (Refer to Fig. 23.)
Check that the top margin of the print result is 3mm±0.25mm.
(8) Click the "OK" or "NG" button in accordance with the inspection result and finish
margin adjustment.
If the margin is adjusted, select the appropriate
Adjusted value and click the "Apply (2)" button.
Print result (C)
Fig. 23 "Adjustment print test" screen
21
3mm±0.25mm
Printing direction
Print the print pattern
for inspection.