[ 8 ] Removing the Roller Holder ASSY, Thermal Head Unit, and Tape Feed Motor from
the Frame ASSY
(1) Remove the retaining ring and pull up the cassette rod.
(2) Remove the retaining ring from the roller holder ASSY.
(3) Unhook the roller holder release spring from the roller holder ASSY and take out the
ASSY and the spring.
NOTE: When unhooking the spring, take care not to scratch the thermal print head
and its flat cable.
(4) Remove two screws "b" and take off the thermal head unit.
CAUTION: Do not loosen or remove screws "X."
(5) Remove the retaining ring from the release lever, then take out the release lever,
release rod, and spring.
(6) Push the release rod roller out of the release rod.
(7) Remove two screws "a" and take off the tape feed motor.
Fig. 2.2-15 Removing the Roller Holder ASSY, Thermal Head Unit, and Tape Feed Motor
II - 19