Brother QL-1060N Service Manual page 64

(3) Put the ferrite cores of the head cables and tape feed motor harness into the place
provided on the under cover as shown in the figure below.
Tape feed motor harness
(4) Bind the harnesses of the cutter unit ASSY with the fastening band.
Note: Be sure to bind the harnesses securely so that there is no looseness.
Cover left sensor ASSY
Fastening band
Cutter motor ASSY
Mecha ASSY
Ferrite core
Fig. 3.2-15 Installing the Mecha ASSY and Cutter unit ASSY (3)
Cutter unit ASSY
Cover left sensor ASSY
Fastening band
Fig. 3.2-16 Installing the Mecha ASSY and Cutter unit ASSY (4)
Cutter motor ASSY
III- 36
Ferrite core
Head cable
Under cover