Table of Contents
Advertisement
5.
MATERIALS
5-1
Switching Firmware
Use the following steps to switch the firmware of the device.
1.
Install the flash memory loading program into your PC.
2.
Copy the firmware to any folder.
3.
Turn off the power to the device, then mount either the serial, USB or LAN interface.
4.
Turn the device's DIP switch #1 and #2 to OFF (the right side).
The DIP switch is on the side of the magnetic head, when looking from the top of the
device and on the inlet side is #1.
5.
Connect the interface cable, then turn the power on again.
6.
The LEDs will flash alternately several times and STATUS will light. The buzzer will beep
twice.
7.
Startup the flash memory loading program.
conditions. When using a LAN interface, set the IP address.
completed, click OK.
8.
Use flash memory loading program WRITE! to select the firmware.
9.
Loading starts.
Do not turn the power off or unplug the cable until completed.
10.
When completed, turn off the power and return the DIP switches #1 and #2 (left side) and
interface to their normal statuses.
Caution
• The communication speed when loading the mechanism part for the device is fixed at 19200
bps, 8 bits, non-parity.
Use PORT! to set the communication
70
When settings are
Advertisement
Table of Contents
