Table of Contents
Advertisement
• Expansion starting Y address parameter
Specifies whether to expand the registered image Y address to the rasterized image register
buffer.
Becomes 0 when omitted. Specify in bytes (8 dot units).
adjustments to the image print position in the Y direction, adjust the top and bottom margins on
the image data.
'0' to "39"
• Expansion image data parameter
Expresses each 8 dots using two characters of text.
LSB specifies the upper side bits; MSB specifies the lower side bits. In the example below, this
is "3A." The maximum value that can be specified for image data is 1024 bytes (512 x 8 dots).
The number of image data should be an integer magnification of the image length.
Bit 0
Bit 1
Bit 2
Bit 3
Bit 4
Bit 5
Bit 6
Bit 7
If using a card in the vertical direction (portrait), you should rotate the original print data
beforehand.
'3' (33h)
'A' (41h)
32
When making minute
Advertisement
Table of Contents
