Removing The Protective Materials; Installing The Platen Knob; Opening The Front Cover - Star Micronics LC-7211 User Manual

5
Front cover
Capot avant
Frontabdeckung
Coperchio anteriore
Card board
Carton
Pappe
Cartone
Protection sheet
Feuille de protection
Schutzstreifen
Foglio protettivo
Front cover
Capot avant
Frontabdeckung
Coperchio anteriore

Removing the protective materials

Protective sheets and a piece of cardboard are
inserted into the printer to protect components during
shipping. Before using the printer, be sure to remove
all packing material from inside the front cover as
shown in the illustration.

Installing the platen knob

The platen knob is packed into a recess in the
packaging material.
Install the knob on the shaft located inside the
large hole on the right side of the printer. Make
sure that the flat side of the shaft is aligned with
the corresponding flat surface inside the knob's
spindle. Press the knob carefully but firmly into
place as far as it will go.

Opening the front cover

Hook your fingers under the two small tabs on
either side of the front cover and pull forward and
up to swing the front cover open.