Star Micronics SP298 User Manual

Star micronics sp298: user guide

Hide thumbs Also See for SP298:

Removing the protective materials

Four protective materials are inserted into the printer to protect components during

shipping. Before using the printer, be sure to remove all protective materials as

shown in the illustration.

Remove the two pieces of protective tape.

Pull the protective sheet straight out toward the front of the printer.

Push in the side of the printer cover and lift it upward to remove it.

Remove the packing materials.

Note that it is a good idea to keep all protective materials in case you will need to

pack the printer up again and send it somewhere at a later date.

Printer cover

Packing

material

Protective sheet

CAUTION

Protective tape

SP298 80871055

Table of Contents

Do you have a question about the SP298 and is the answer not in the manual?

Page 1: Removing The Protective Materials
Remove the two pieces of protective tape. Pull the protective sheet straight out toward the front of the printer. Push in the side of the printer cover and lift it upward to remove it. Remove the packing materials. Note that it is a good idea to keep all protective materials in case you will need to pack the printer up again and send it somewhere at a later date.
Page 2: Autoside Loading
At least 3cm Push the right edge of the paper into the printer until it stops. At that time, the PAPER OUT indicator will go out, and the printer mechanism will automatically align the paper for printing from the top.