Table of Contents
Advertisement
(10) Print
discharge command
This command prints only to the print surface.
If there is a card idling in the device, it prints to the card.
If there is no targeted card, it will wait until one is inserted into the device, then starts printing.
After printing, the device will either discharge the card according to the discharge method
specification parameter or it will stop while idling and hold the card.
Discharged cards wait to be pulled out and are no longer process target cards.
The device stops at the front idling position, and the card being held is a process target card.
The print expansion buffer and rasterized image register buffer are not cleared with the
execution of the print command.
If a card is not inserted after this command is issued, or to cancel the command, issue the card
insertion wait status cancel command (54h).
The processing time can vary depending on the card type, ambient temperature and head heat.
Command Transfer Formats
STX
47h
Response Transfer Format
STX
47h
Parameter Explanation
• Discharge method specification parameter
'0':
Card after print is stopped at front idling position and held
Card becomes a process target card.
'1':
Card after print is discharged.
Card waits to be pulled out and is not a process target card.
'2'
Card after print is discharged to back side.
Cannot be used with case accessory parts. Reject response is issued.
Discharge method
specification
Status
ETX
ETX
BCC
BCC
38
Advertisement
Table of Contents
