Table of Contents
Advertisement
• Expansion starting dot specification parameter
The expansion starting dot is the BMP file height that corresponds from '0,' minus 1. When it is
not less than the expansion ending dot specification parameter, an error will occur.
• Expansion ending dot specification parameter
The expansion ending dot is the BMP file height that corresponds from '0,' minus 1. When it is
not more than the expansion starting dot specification parameter, an error will occur.
Note that to print a progress bar, two images that extend the progress in the Y direction, as
shown below for the BMP file to register with the command (4Bh), must be registered.
As an example, the following will register three empty progress bars, and four full progress bars.
The height of the BMP is 100 dots.
1. 4Ah 1, 100, 25, 3, 0, 99
This arranges an empty progress bar from the 0 dot to the 99th dot on a horizontally
arranged card.
2. 4Ah 1, 100, 25, 4, 0, 39
This arranges an empty progress bar from the 0 dot to the 39th dot on a horizontally
arranged card.
The result is that image 4 overlaps image 3, and 40% of the progress bar is image
expanded.
3. This can be printed to the card by executing the 46h command.
41
Advertisement
Table of Contents
