Star Micronics TCP300 Programmer's Manual page 42

Command Transfer Formats
STX 4Ah
','
Response Transfer Format
STX 4Ah
Parameter Explanation
• Data arrangement specification parameter
To specify whether to use the internal vertically or horizontally, select '0' to '3.'
'0': Vertical card + overwrite
'1': Horizontal card + overwrite
'2': Vertical card + added writing
'3': Horizontal card + added writing
These four parameters specify how to write.
• ',' (Comma)
Required to separate parameters.
• Data arrangement X coordinate parameter
Specifies the X coordinate on the upper left edge of the image to expand.
When the data arrangement specification is '0,' '2': '0' to "319"
When the data arrangement specification is '1,' '3': '0' to "479"
• Data arrangement Y coordinate parameter
Specifies the Y coordinate on the upper left edge of the image to expand.
When the data arrangement specification is '0,' '2': '0' to "479"
When the data arrangement specification is '1,' '3': '0' to "319"
• Expansion image specification number parameter
The data count can be up to 16 types and can be specified using the characters of '0' to "15."
However, a reject response is issued if an image data that corresponds to the reader/writer flash
ROM2 cannot be found.
Data ',' Data arrangement
arrangement X coordinate
specification
Expansion ',' Expansion starting
image dot
specification
number
Status ETX
',' Data arrangement
Y coordinate
',' Expansion ending
dot
BCC
40
ETX BCC