Table of Contents
Advertisement
'7':
Enables magnetic writing to track 1, 2 and 3.
The ex-factory default setting is for '2,' to enable magnetic writing to track 2.
• Card arrangement direction setting
This command sets the direction for card arrangement. In the print character data setting
command (41h), the settings made using this command are enabled for the card arrangement
direction if the card arrangement direction and data arrangement coordinate printing control
header string are not set. In the print character data setting command (41h), if the print control
header string is not set, the subsequent print character data is enabled with card arrangement
direction set by the printing control header string having priority.
direction set by this command is enabled again for each printing on cards.
STX, 91h, 'P'/'p', card arrangement direction setting, ETX, BCC
Card arrangement direction setting parameter
'0': Sets vertical card direction as the initial direction.
'1': Sets horizontal card direction as the initial direction.
The card arrangement direction when the device is shipped from the factory is set to the vertical
position.
• Magnetic stripe read retry count setting
This command sets the number of times the device will retry reading the magnetic stripe.
STX, 91h, 'R'/'r', magnetic stripe read retry count setting, ETX, BCC
Magnetic read retry count setting parameters
'0':
No retry
'1':
Sets the magnetic read retry count to 1 time.
'2':
Sets the magnetic read retry count to 2 times.
'3':
Sets the magnetic read retry count to 3 times.
'4':
Sets the magnetic read retry count to 4 times.
'5':
Sets the magnetic read retry count to 5 times.
'6':
Sets the magnetic read retry count to 6 times.
'7':
Sets the magnetic read retry count to 7 times.
The ex-factory magnetic read retry count setting is 2 times.
63
The card arrangement
Advertisement
Table of Contents
