Table of Contents
Advertisement
'8':
Sets the transport speed to 255 mm/s.
'9':
Sets the transport speed to 285 mm/s.
'A':
Sets the transport speed to 315 mm/s.
'B':
Sets the transport speed to 345 mm/s.
'C':
Sets the transport speed to 375 mm/s.
'D':
Sets the transport speed to 405 mm/s.
'E':
Sets the transport speed to 435 mm/s.
'F':
Sets the transport speed to 450 mm/s.
The ex-factory transport speed setting is 405 mm/s.
• LED control method setting
This command sets the method to control the LED.
When setting the LED control method, the LED automatically lights and the buzzer rings when
the device has entered a card insertion wait state or card removal wait state.
•
STX, 91h, 'L'/'l', operation setting, ETX, BCC
Operation setting parameters
'0':
LED does not light and buzzer does not ring when there is a card inserting request or
removal request.
'1':
Buzzer rings when there is a card removal request.
LED displays an insertion request.
'2':
LED lights to display there is a card removal request.
LED displays an insertion request.
'3':
LED lights and buzzer rings to display that there is a card removal request.
LED displays an insertion request.
• Setting for the ex-factory defaults
This command returns settings that users can make to their ex-factory, default status. This
does not initialize TPH rank, EHD rank, media type or energy changes.
STX, 91h, 'O'/'o', '0', ETX, BCC
Alphabet
• Magnetic format Settings
Users can use this command to freely set the magnetic stripe writing format.
Magnetic format setting parameters
Number
67
Advertisement
Table of Contents
