Service Software; General; Hardware Requirements For Windows 3.1X; Hardware Requirements For Windows 95 - Nokia NSE-6 SERIES Service Manual

PAMS
Technical Documentation

Service Software

General

To run the After Sales SW, a parallel port software protection device
(PKD–1) has to be connected. TDF–4 box must connected to PC for
flashing purposes. The user can use WinTesla functions in modules for
testing NSE–1/3/6 and NSM–1 mobile stations (MS). The test functions
send test messages from PC to MS and receive results and show them in
the PC display. The messages can be sent via M2BUS or FBUS.
Note: if this software is to be run on laptops, the power saving feature
MUST be switched off.

Hardware requirements for Windows 3.1x

The recommended minimum hardware standard to run Service Software
is any computer which is 386 33 MHz or greater with at least 4 MB of
memory and VGA type display (640 x 480). This assumes that only the
WinTesla with After Sales Support Modules is active, i.e. other Windows
packages are not running in the background.

Hardware requirements for Windows 95

The recommended minimum hardware standard to run Service Software
is any computer which has Pentium processor, memory 8 MB and meets
HW requirements recommended by Microsoft.

Software Environment of the Support Modules

The Service Software user interface is intended for the following environ-
ments: Microsoft Windows 3.1x (enhanced mode) and Windows 95 envi-
ronment running in enhanced mode. Support for Microsoft NT may be
added, if required. Detailed information about Windows and application
usage can be found from the Microsoft Windows Version 3.1 Users Guide
chapter one (Windows Basics) and chapter two (Application Basics).
As an ordinary Windows application, the main idea in the user interface is
that selections are made with menus, push buttons and shortcut keys.
Selections can be done by using keyboard and/or mouse. There is always
a status bar displayed at the bottom of the main window which contains
information about current actions.
Original 08/98
NSE/M–1/3/6
Service Software Instructions
Page 5