Nokia NSE-6 SERIES Service Manual page 131

PAMS
Technical Documentation
When calibration is ended, the DAC value checking is made and if it is not
succeeded, error message is shown.
When exit is made, the next selections are set to the values which were
selected before this adjustment.
The exit and the use of AGC–control values is done same way as exit
from power level tuning and power coefficient use:
NSM–1 Specific Features
When tuning NSM–1 phones both bands must be tuned. Tuning is always
started in GSM band. If current band is PCN, user is asked to confirm
band change or cancel tuning with following dialog.
If PCN band was selected, when tuning was selected, tuning is automati-
cally continued in PCN band, after saving tuning values in GSM band. If
tuning was started in GSM band, user is asked to continue tuning in PCN
band.
If user wants to cancel tuning without saving values in PCN band, there is
two confirmation dialogs to make sure that user does not accidentally
cancel tuning in PCN band.
To cancel tuning answer No to first dialog and Yes to second dialog.
When dialog is closed original band is selected.
Original 08/98
Operation Mode
Update RF Information window
NSE/M–1/3/6
Service Software Instructions
Page 29