Nokia NSE-6 SERIES Service Manual page 141

PAMS
Technical Documentation
Note! Function is activated immediately, Apply is not needed.
TX radio button (ALT+T):
When TX is selected, the next functions are made:
– Operation mode is set to burst
Continuous mode radio button is disabled.
Note! Function is activated immediately, Apply is not needed.
Operation Mode group:
Continuous radio button (ALT+C):
When continuous selection is used,
Channel selection
Note! Function is activated immediately, Apply is not needed.
Burst radio button (ALT+B):
When burst selection is used,
suring synthesiser control sequence
toring Channel selections
and the TX power is connected
Note! Function is activated immediately, Apply is not needed.
TX Data Type drop list (ALT+D):
TX Power Level edit box (ALT+T):
With this value is possible to change the transmission power. The user
can give the needed power value or select the test value, which is tuned
with TX power tuning function. The test value is found at the end of the
list.
TX Power have value OFF and is disabled ( greyed ) when active unit is
RX. When the TX power is tuned with test value (smallest value) the TX
Power has value TEST .
Original 08/98
Data transmission is activated
If operation mode is continuous,
RF Information window is updated
synthesiser is set to constant frequency
synthesiser channel number is as given with Continuous Mode
transmitter power is not connected
if Active Unit is RX, AGC is controlled
synthesiser is controlled by using receiving/transmission/mea-
synthesiser channel numbers are as given with Channel/Moni-
if Active Unit is TX, data (selected with TX Data Type) is sent
NSE/M–1/3/6
Service Software Instructions
Page 39