Required Equipment; Equipment Setup - Nokia NSE-6 SERIES Service Manual

NSE–6
Tuning Instructions

Required Equipment

– PC/AT computer with service software; see separate section for
instructions on installation and use.
– Service accessories; see equipment setup pictures.
– Multimeter or DVM.
– GSM radio telephone test station or separate measuring equipment as
follows:

Equipment Setup

Caution: Make sure that you have switched off the PC and the printer
Caution: Do not connect the PKD–1 key to the serial port. You may
Attach the protection key PKD–1 to parallel port one (25–pin female
D–connector) of the PC. When connecting the PKD–1 to the parallel port
be sure that you insert the PC end of the PKD–1 to the PC (male side). If
you use a printer on parallel port one, place the PKD–1 between the PC
and your printer cable.
Next connect the M2BUS service cable, DAU–9S, to the serial port
(RS–232) of the computer. Attach one end of the service cable to the PC
serial port and the other end to the service box, JBA–4. For servicing the
phone with the covers in place the service box should always be used.
When the phone covers are removed the jigs should be used.
For audio measurements connect the audio cable, ADS–1, as follows:
– EAR line to AF INPUT of test equipment
– MIC line to MOD GEN OUTPUT of test equipment
Page 4
– RF generator
– pulse power meter
– spectrum analyzer
– attenuator and branching unit
before making connections !
damage your PKD–1 !
PAMS
Technical Documentation
Original 08/98