Normal Mode; Local Mode - Nokia NSE-6 SERIES Service Manual

PAMS
Technical Documentation

Normal Mode

Activation
Alt, P, N
F5
When normal mode has been activated or program has been started,
self–test results will be asked from MCU. If any fault was found in the
tests, an error message is shown. If normal mode has been set success-
fully (no self test error has been found), and paging listening has been
started, the used AFC value is requested from MS.
Initialisation routine checks phone's cellular type and if unsupported
phone is detected, application unloads the DLLs.
The After Sales SW sets automatically the MS state to normal mode
when needed.
If phone identification view is open, window will be automatically updated.
Also if RF Information Window is open it will be updated to quick info
view.
NOTE: When phone is changed to but phone type does not change, user
may select Product/Initialise/Normal Mode instead of Product/New.

Local Mode

Activation
Alt, P, L
Shift+F5
Selection will change the MS state to local . When user selects item from
Testing or Tuning menus, the After Sales SW software will change auto-
matically the MS state to local.
The After Sales SW sets automatically the MS state to normal mode
when needed.
Also if quick info view is open it will be updated to RF Information view.
Band... command
This menu selection is available only for NSM–1 phones.
Activation
Alt, P, B
Original 08/98
Status Bar Text
Initialises phone to normal mode
Status Bar Text
Initialises phone to local mode
Status Bar Text
Opens a submenu which contains following options:
NSE/M–1/3/6
Service Software Instructions
Page 25