Connections; Internal And External Call Numbers; External Seizure And Entry Of Call Numbers - Proximus Forum 500 User Manual

Alarm auto answer: If the function is activated, any call is automatically
accepted during Pre call. If the function is deactivated and there is an
incoming call during pre-alarm, or a call already being made, the alarm
call number is dialled after pre-alarm.
No matter what the setting, calls from the alarm call number or the
SOS emergency call number are automatically accepted and pre-alarm
ended.
Alarm tone: Pre-alarm can take place with/without an alarm tone on the
mobile unit. When the alarm tone is activated, it is signalled with
increasing volume.
Repeat alarm: This is the time interval after which another pre-alarm
including subsequent dialling of the alarm call number is executed (e.g.
because calling the alarm call number was cancelled by the system).
Handsfree in alarm: You can configure whether an alarm call is done in
handsfree or receiver operation. This setting also applies to the emer-
gency call via the SOS emergency call key.
Several alarm types simultaneously activated
Do not activate the three alarm sensor types simultaneously when short
delay and repeat times are set and the pre-alarm is switched off. This may
block the menu access (to deactivate an alarm type) in case of a simultaneous
alarm call. Place the mobile unit in the charger and keep it placed there. Make
your configurations then.

Connections

Internal and External Call Numbers

Internal and external call numbers for reaching you are assigned during
configuration of the Forum 500 / Forum 5000 communications system.

External Seizure and Entry of Call Numbers

If you hear the external dialling tone after pressing the
telephone is set to spontaneous external line seizure. If you hear the internal
dialling tone after pressing the
external line seizure. The external line seizure applicable for you is configured
by your system administrator upon user group configuration.
Basic Functions
call key, your telephone is set to manual
Connections
call key, your
51