JVC GY-DV5000U Service Manual page 44

No. Item
§ ¶
21 Arm gear/ Control arm
Control arm
Stud
Hole on the control arm
•
22 Control plate/ Mode sensor gear
Control plate
2-20
Ref. Illustration
Arm gear
Multemp SH-P
M 3
See in section 5.
Fig. 2.6.21 (1)
Arm gear
Fig. 2.6.21 (3)
2
Mode sensor gear
Fig. 2.6.22 (1)
<Disassembly>
Arm gear:
1) Remove the main cam as described in No. 20 and
remove the arm gear.
Control arm:
1) Place the main deck upside down.
2) Bend the control plate slightly, disengage the con-
trol arm's stud from the groove on the plate and
remove the control arm. (Refer to Fig. 2.6.21(2))
<Assembly>
1) Reverse the disassembly procedure.
2) Align the hole on the control arm withy that on the
main deck.
3) Align the hole on the arm gear with that on the
main deck.
Control plate
<Disassembly>
Control plate:
1) Place the main deck upside down.
2) Slide the control plate in the direction of the arrow
1 to remove.
Mode sensor gear:
1) Remove the mode sensor gear as if pulling it out.
<Assembly>
1) Attach the control plate.
2) Slide the control plate in the direction of the arrow
2.
3) Attach the mode sensor gear so that the hole on it
is aligned with that on the control plate.
Control Plate
1
Procedure
Control arm
Stud
While raising
this end, remove
by pulling out
the studs of the
control arm.
Fig. 2.6.21 (2)
Mode Sensor
Gear
Attach in position where
holes are facing each other.
Fig. 2.6.22 (2)