Profienergy In The Motor Starter - Siemens SIMATIC ET 200SP Manual

Product overview
3.7 Functions
3.7.29.2

PROFIenergy in the motor starter

The SIMATIC ET 200SP motor starter supports the "Energy saving function" and "Measured
value function" for the motor current. These are identified as commands, since they trigger
reactions in the SIMATIC ET 200SP motor starter.
In addition, the SIMATIC ET 200SP motor starter also provides so-called services that
provide information on the status of the motor starter as defined in PROFIenergy. These can
then be evaluated and further processed in the user program.
Using PROFIenergy with the SIMATIC ET 200SP motor starters
SIEMENS provides two function blocks for using PROFIenergy:
● PE_START_END (FB815) supports the switch to an energy-saving mode.
● PE_CMD (FB816) supports the reading out of measured values and the switch to an
energy-saving mode
You will find further information in the document entitled "Common Application Profile
PROFIenergy, Technical Specification for PROFINET Version V1.1 Edition 2, Dec. 2013,
Order Number 3802" published by PROFIBUS Nutzerorganisation e.V. (PNO).
Note
PROFIenergy is not possible with PROFIBUS interface modules.
Note
The PROFIenergy function is available with firmware version V3.3 of the interface modules.
Commands
The following tables show the supported commands:
Control commands
Start_Pause
Start_Pause_with_time_response
End_Pause
Status commands
PE_Identify
PEM_Status
PEM_Status_with_time_response
82
The starter switches to energy-saving mode.
The starter switches to energy-saving mode and signals its
minimum idle times.
The starter switches back to operating mode.
Provides a list of supported PROFIenergy commands/functions.
Returns the current mode.
Returns the extended status of the current mode.
Manual, 12/2016, A5E34821005002A/RS-AB/002
Motor starter (3RK1308-0**00-0CP0)