Table of Contents
Advertisement
Chapter 4 - Jumper Settings
Jumper Settings (MB330-CRM)
Clear CMOS Data (MB330-CRM)
Line-out
If you encounter the following,
a) CMOS data becomes corrupted.
b) You forgot the supervisor or user password.
you can reconfigure the system with the default values stored in the ROM BIOS.
To load the default values stored in the ROM BIOS, please follow the steps below.
1. Power-off the system and unplug the power cord.
2. Set JP9 pins 2 and 3 to On. Wait for a few seconds and set JP9 back to its default setting,
pins 1 and 2 On.
3. Now plug the power cord and power-on the system.
Chapter 4 Jumper Settings
Chapter 4
JP9
1 2
3
1
2
3
1-2 On: Normal
2-3 On:
(default)
Clear CMOS Data
PS/2 Keyboard/Mouse Power Select (MB330-CRM)
Line-out
JP1 is used to select the power of the PS/2 keyboard and PS/2 mouse ports. Selecting +5V_
standby will allow you to use the PS/2 keyboard or PS/2 mouse to wake up the system.
Important:
The +5VSB power source of your power supply must support ≥720mA.
17
1
2
3
JP1
1-2 On: +5V
(default)
1
2
3
2-3 On: +5V_
standby
www.dfi.com
Advertisement
Table of Contents
