Table of Contents
Advertisement
Super IO Configuration
This section is used to configure the I/O functions supported by the onboard F71879 Super
I/O chip.
Restore AC Power Loss
Power Off
When power returns after an AC power failure, the system's power is off. You must
press the Power button to power-on the system.
Power On
When power returns after an AC power failure, the system will automatically power-on.
Last State
When power returns after an AC power failure, the system will return to the state
where you left off before power failure occurs. If the system's power is off when AC
power failure occurs, it will remain off when power returns. If the system's power is on
when AC power failure occurs, the system will power-on when power returns.
Watchdog Timer
Selects the watchdog timer unit: second or minute.
Chapter 7 BIOS Setup
Chapter 7
Super IO Watchdog Timer
Sets the timeout value of the super IO watchdog timer. 0 means disabled.
Serial Port 1 & Serial Port 2 Configuration
Sets the parameters
of serial port 0 (COM A) and serial port 1 (COM B).
Serial Port
Enables or disables the serial port (COM).
Change Settings
Selects the IO/IRQ setting of the I/O device.
54
www.dfi.com
Advertisement
Table of Contents
