DFI WM343-MB User Manual page 31

Desktop box pc
Hide thumbs Also See for WM343-MB:
Table of Contents

Advertisement

Front Panel Connector
Line-out
HDD-LED - HDD LED
This LED will light when the hard drive is being accessed.
RESET SW - Reset Switch
This switch allows you to reboot without having to power off the system.
PWR-BTN - Power Switch
This switch is used to power on or off the system.
PWR-LED - Power/Standby LED
When the system's power is on, this LED will light. When the system is in the S1 (POS - Power
On Suspend) state, it will blink every second. When the system is in the S3 (STR - Suspend To
RAM) state, it will blink every 4 seconds.
Pin Pin Assignment
3
HDD Power
HDD-LED
5
Signal
7
Ground
9
RST Signal
RESET SW
11
N.C.
Chapter 5 Ports and Connectors
Chapter 5
1
2
PWR-LED
HDD-LED
PWR-BTN
RESET-SW
11
12
Pin Pin Assignment
2
LED Power
4
LED Power
PWR-LED
6
Signal
8
Ground
PWR-BTN
10
Signal
Expansion Slots
Line-out
PCI Express x16
PCI 1
PCI 2
PCI Express x4
Mini PCI Express
PCI Express x16 Slot
Install PCI Express x16 graphics card, that comply to the PCI Express specifications, into the
PCI Express x16 slot. To install a graphics card into the x16 slot, align the graphics card above
the slot then press it down firmly until it is completely seated in the slot. The retaining clip of
the slot will automatically hold the graphics card in place.
PCI Express x4 Slot
Install PCI Express cards such as network cards or other cards that comply to the PCI Express
specifications into the PCI Express x4 slot.
PCI Slots
The PCI slot supports expansion cards that comply with PCI specifications.
Mini PCIe Slot (not supports m-SATA)
The Mini PCIe socket is used to install a Mini PCIe card. Mini PCIe card is a small form factor
PCI card with the same signal protocol, electrical definitions, and configuration definitions as
the conventional PCI.
31
www.dfi.com

Advertisement

Table of Contents
loading

Table of Contents