Wiring And Connecting Ac Power Via The 100W High Voltage Power Supply; Table 23 Connecting The 100W High Voltage Power Supply To The 7705 Sar-A; Figure 21 Dc Power Cable - Alcatel-Lucent 7705 SAR-A Installation Manual

Note:
1.
Wiring and Connecting AC Power via the 100W High
Voltage Power Supply
Required tools and hardware:
Follow these steps to wire and connect an AC power supply to the –48 VDC power feed
inputs on the 7705 SAR-A terminal block via the 100W High Voltage Power Supply.
Figure 20
Step 1. Prepare the open-ended DC output wire from the 100W High Voltage Power
7705 SAR-A Chassis Installation Guide
Table 23: Connecting the 100W High Voltage Power Supply to the 7705 SAR-A
Key Description
1 0.35 in. (9 mm) of outer shielding removed from each wire to expose the
conductor
2 100W High Voltage Power Supply
3
Single-feed high voltage AC or DC input (IEC 320-C14 connector)
Two AC cord sets are supplied with the 100W High Voltage Power Supply to match North American and
European style AC outlets. Both cord sets have an IEC 320 C13 female connector (plug) at one end.
• one 100W High Voltage Power Supply (two are required for redundant power
configurations)
• wire stripper
• torque driver for slot screws; No. 2 slotted blade width, 0.125 in (3.2 mm)
shows the terminal connections;
Supply by stripping 0.35 in. (9 mm) of insulation from each power cable at the
router end, as shown in
100W High Voltage Power Supply Connections
Table 23 identifies the key items in the figure.
Figure 21. Table 24
Figure 21: DC Power Cable
2
1
identifies the key items in the figure.
1
23318
91