Table of Contents
Advertisement
3 Components and Power Supply
Installing the transparent protector
Fig. 8:
3.3 Power Source
The OA5725R router family must be powered through DC voltage to 48 V DC.
Note
Before connecting the router, please read the following instructions carefully.
Workplace. Main characteristics
• The device should not be placed amongst papers, magazines or other elements that could hinder natural air circu-
lation.
• Knocks and/or strong vibrations should be avoided during transport, operation and storage.
Warning
The electric current in power cables, telephone lines and communication cables is dangerous. To pre-
vent electric shocks, before installing, handling or opening the equipment covers, connect and discon-
nect the cables following the steps set forth in
3.3.1 Connecting the Power Supply
To connect the power supply to the router, please follow the steps set forth in
Warning
To avoid electric shocks, residual current circulation and other unwanted effects, also affecting commu-
nications, the following is recommended:
All interconnected communication devices should be plugged to THE SAME GROUNDED POWER
OUTLET, which should at the same time be of good quality (lower than 10 ohms).
Whether the workplace is provided with an uninterrupted power supply system (UPS), regulated supply
or it is independent from the rest (such as lighting, etc.); it is highly recommended that all data devices
should be connected to the same power source. This will avoid operating and premature aging prob-
lems of drivers and other components.
10
To Connect
on page 11 and
To Disconnect
To Connect
Alcatel-Lucent Enterprise
on page 11.
on page 11.
OA5725R Router
Advertisement
Table of Contents
