7705 Sar-A Connectors And Leds; Table 28 7705 Sar-A Connector And Led Descriptions; Figure 28 7705 Sar-A Connectors And Leds (Variant With T1/E1 Ports) - Alcatel-Lucent 7705 SAR-A Installation Manual

7705 SAR-A Connectors and LEDs

7705 SAR-A Connectors and LEDs
Figure 28
equipped with T1/E1 ports.
Figure 28: 7705 SAR-A Connectors and LEDs (Variant with T1/E1 Ports)
3
Lnk Act Lnk
Status
1A
Table 28
Key Label/Part
1 Ethernet Ports
120
identifies the connectors and LEDs on the front of the router. The variant shown is
7705 SAR-A
Act Lnk Act Lnk Act
2A 3A 4A 1B 2B 3B 4B 5
Ethernet
1
describes the connectors and LEDs on the 7705 SAR-A.
Table 28: 7705 SAR-A Connector and LED Descriptions
Sub- Description
category
SFP ports Ports 1B to 4B and ports 5 to 8 are SFP ports. The SFP port number is
displayed below each port.
RJ-45 Four Gigabit Ethernet ports have RJ-45 connectors that are numbered 1A
connectors to 4A. The RJ-45 ports numbered 9 to 12 support Fast Ethernet. The port
numbers are displayed below each port. The associated Lnk (link) LED
is located at the top-left corner of the port, and the associated Act
(activity) LED is located at the top-right corner of the port.
Lnk LED Green: Indicates that the link is up
Unlit: Indicates that there is no link, or that the link is operationally
down, disabled or shut down
Act LED Amber (blinking): Indicates that the port is active (receiving or
transmitting)
Unlit: Indicates that the port is down or disabled
1
Stat
Lnk Act Lnk Act Lnk Act Lnk Act
6 7 8 9 10 11 12 Stat
2
7705 SAR-A Chassis Installation Guide
5 6
Mgmt
3 5 7
Stat Stat Stat
Lnk Act
-48 VDC
Console
In
Stat Stat Stat Sync ToD Out
4 6 8
T1/E1
2 4 7 8
9
23334