Table 16 Chassis Ground Connection Components; Figure 16 Attaching The Chassis Ground Connector (Cable Routed Up) - Alcatel-Lucent 7705 SAR-A Installation Manual

Chassis Ground Wiring
To make the chassis ground connection:
Step 1. Run a single length of #18 AWG wire (minimum) from the ground point (building
Step 2. Using a wire-stripping tool, strip the insulation from the wire according to local
Step 3. Remove the Keps nut and star washer from the ground stud on the mounting
74
Figure 16: Attaching the Chassis Ground Connector (Cable Routed Up)
Table 16: Chassis Ground Connection Components
Key Description
1 Lance
2 Cable tie
3 Chassis ground stud (4 mm diameter, nominal)
4 Keps nut
5 Star washer
6 Ring lug and chassis ground wire (green/yellow)
ground or equipment ground bus) to the chassis ground stud.
safety codes and crimp the ring lug to the wire
bracket.
4 6 5 3
Mgmt
Lnk
Act
-48 VDC
Con sole
In
Sync
ToD Out
7705 SAR-A Chassis Installation Guide
2
1
3
(Figure 14).
23325