Installing The Chassis In A Rack; Rack-Mounting The Chassis; Figure 13 Installing The 7705 Sar-A Chassis In A Rack - Alcatel-Lucent 7705 SAR-A Installation Manual

Installing the Chassis in a Rack

Installing the Chassis in a Rack

Rack-Mounting the Chassis

The 7705 SAR-A chassis is designed for installation in a 19-inch rack. The rack-mount
brackets are factory-installed.
Table 14
1
70
Note: Ensure that you observe the Dangers and Warnings that are described in
Preparation that pertain to grounding and installation before you install this equipment.
lists the rack-mounting components.
Warning:
• Non-conductive coatings (such as lacquer and enamel) must be removed from threads
and other contact surfaces to ensure electrical conductivity. Thread-forming screws with
paint piercing washers may be used for this purpose during installation.
• When rack-mounting the chassis in an equipment rack, do not stack one 7705 SAR-A
chassis or any other equipment directly on top of another 7705 SAR-A chassis, such
that the bottom chassis is supporting other devices. Each chassis must be secured in
the rack with the appropriate mounting apparatus.
Figure 13: Installing the 7705 SAR-A Chassis in a Rack
Lnk
Act Lnk
Act Lnk Act
Lnk Act
Status
1A
2A 3A
4A
1B
2B 3B
4B
Ethernet
Figure 13 illustrates the installation of the chassis in a rack.
3
7705 SAR- A
1
3
Stat Stat
Lnk Act
Lnk Act Lnk
Act Lnk
Act
5
6 7
8 9
10
11
12
Stat
Stat
2
4
T1/E1
7705 SAR-A Chassis Installation Guide
5 7
Mgmt
Stat
Stat
Lnk
Act
-48 VDC
Console
Stat
Stat
6
8 Sync In
ToD Out
4
2
Site
23323