Ssh Connection; Figure 27 Management Port Connection - Alcatel-Lucent 7705 SAR-A Installation Manual

Establishing Router Management Connections
To establish a console connection:
Step 1. Connect the terminal to the Console port on the front panel
Step 2. Power on the terminal.
Step 3. Establish the connection by pressing the <Enter> key a few times on your terminal
Step 4. At the router prompt, enter the login and password.

SSH Connection

SSH access provides the same options for user and administrator access as those available
through the console port or Telnet; however, SSH is more secure than Telnet. You can access
the router with an SSH connection from a PC or workstation connected to the network once
the following conditions are met:
CLI Syntax:
where:
address is an IPv4 or IPv6 address
Lnk Act Lnk
Status
1A
114
RJ-45 CAT5e cable.
keyboard.
The default login is admin.
The default password is admin.
• the router has successfully initialized
• the Management port
command (see CLI Syntax)
bof
address ip-prefix/ip-prefix-length [primary |
Note: SSH connection attempts after a reboot may generate key warnings as the node
generates new SSH keys on each reboot. To avoid these key warnings, enable key
preservation using the config>system>security>ssh>preserve-key command.
Figure 27: Management Port Connection
Act Lnk Act Lnk Act
2A 3A 4A 1B 2B 3B 4B 5
Ethernet
(Figure 27) has been configured using the bof>address
secondary]
7705 SAR-A
Lnk Act Lnk Act Lnk Act Lnk Act
6 7 8 9 10 11 12
7705 SAR-A Chassis Installation Guide
Management port
Mgmt
1 3 5 7
Stat Stat Stat Stat
Lnk Act
Console
In
Stat Stat Stat Stat Sync ToD Out
2 4 6 8
T1/E1
(Figure 26) using an
-48 VDC
23320