Dc Power Connections - Alcatel-Lucent 7705 SAR-A Installation Manual

Step 4. Place the star washer that was removed in step
Step 5. Use a cable tie to secure the ground wire to the lance on the mounting bracket. The
Step 6. Connect the opposite end of the ground wire to the appropriate ground point at your
Step 7. Connect the 7705 SAR-A to the DC or AC power source. See
7705 SAR-A Chassis Installation Guide
such that the wire is angled slightly as it runs down the rack upright
up the rack upright (Figure
in step 3. Tighten the nut to a torque of 8 to 10 lbf-in (0.9 to 1.13 N
Do not over-tighten.
lug will be below the lance if the ground cable is routed downward. The lug will be
above the lance if the ground cable is routed upward.
installation site. Ensure that the chassis ground connection is made according to
local safety codes.
Connections or 100W High Voltage Power Supply
Installing and Grounding the Chassis
3 and the ring lug on the ground stud
16). Secure the lug with the Keps nut that was removed
(Figure
.
m) maximum.
DC Power
Connections.
15) or
75