Alcatel-Lucent 7705 SAR-A Installation Manual page 89

The 7705 SAR-A has a dual-feed, wire-to-board, pluggable terminal block attached to the
front of the chassis. The terminals are the DC power feed points for DC voltage from the
100W High Voltage Power Supply.
Use the 100W High Voltage Power Supply (part number 3HE06972AA) from Alcatel-Lucent
for AC or DC source-to-router connections. The 100W High Voltage Power Supply shipping
container contains:
Figure 19
Supply has a standard IEC 320-C14 connector on 1 ft (0.3 m) of cable at the power input end,
and red and black open-ended wire on 6 ft (1.8 m) of cable at the power output end. The
output feed supplies 54 VDC to the 7705 SAR-A chassis.
7705 SAR-A Chassis Installation Guide
• a 100W High Voltage Power Supply
• a DIN rail bracket and clip attached to the Power Supply, for DIN rail-mount
installations
• instructions detailing how to remove the DIN rail bracket and clip from the unit
• one North American AC power cord with auto-lock feature
• one 240V European AC power cord with auto-lock feature
• two O-ring lugs for a #6-32 screw size
Note:
• Although the 100W High Voltage Power Supply is shipped with O-ring lugs, the ring lugs
are not used for wiring the 7705 SAR-A.
• The 100W High Voltage Power Supply can be installed on a DIN rail, wall, or panel.
• The 100W High Voltage Power Supply input AC interface uses a standard IEC 320-C14
connector; therefore, other AC cords types can be used.
• The minimum size of the power conductor for the AC or DC input connections must be
based on the application, and on the local codes, practices, and regulations applicable
for the region.
shows the 100W High Voltage Power Supply. The 100W High Voltage Power
100W High Voltage Power Supply Connections
89