Menu Structure; Accessing The Menus - Interacoustics OtoRead Instructions For Use Manual

OtoRead™ Instructions for Use - US
Changing instrument settings

Menu Structure

TM
The OtoRead allows the user to change many of the instrument's settings or functions.
The settings are organized into the following structure:
•
Menu 1 (M1):
•
Menu 2 (M2):
•
DPOAE Menu ("DP"):
•
TEOAE Menu (''TE):

Accessing the menus

For a better understanding as to which menu you are currently in,
the menu number can be found in the upper left corner of the
screen.
Wireless Device Pairing, Clearing Test Results, Auto Shutdown
Time
Minimum Amplitude Value, Save Mode, Clock Mode, Language,
and Reset to Default Settings
Level, Averaging Time, Pass SNR, Frequencies to Pass, Reset
Protocol, Save Protocol
Averaging Time, Pass SNR, Frequencies to Pass, Reset Protocol,
Save Protocol
To change the time and date press
then press SETUP at the protocol selection display.
The current date and time presently set in the unit will be shown. If the
time and date are correct, press the
menu.
To access the menus M2, DP and/or TE to change these functions, find
the blue pulsing down arrow and press
to enter the Clock menu. At the Clock menu, hold down the
key for 3 seconds until the 'READY' light (green LED) turns off, and then
release the key.
Please note that editing of the DPOAE and TEOAE settings is only
available if either a TEOAE or DPOAE protocol has been selected.
DPOAE Menu and TEOAE Menu are not accessible in the OtoRead
Screening and Screening Plus Version.
A dedicated flowchart can be found in the diagram below.
CHANGE at the main menu and
UP key to escape back to the main
SETUP at the Protocol Change
Page 29
CHANGE
TM